Tile Adhesives

A factory-made bagged cementitious polymer based powder, containing Portland cement and silica sand, it can be mixed with water for installing small and medium size ceramic floor tiles in interior areas using the thinset method of installation.

 

Features and benefits:

For fixing ceramic tiles on interior floor & wall

Ideal for new floor tiling

Economical & easy to use

Single component - Just add water

 

Certification:

ANSI : Meets ANSI A 118.1 T

EN 12004/ISO 13007: C1T

IS 15477:2019 TYPE 1  T ADHESIVE

VOC: Practically Nil

 

How to apply:

 

Substrate: The surface to be covered with Ceramic tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in: Walls – 3mm in 2.5m Floors – 1.5mm in 1.0m

 

Surface Preparation:

If a plaster/leveling mortar bed is applied, ensure that it is cured for at least 7 days to achieve proper strength before application of tile adhesive for installation of tile

Ensure the substrate is clean and free from impurities like dust, dirt, debris, oil, grease, curing agents, loose plaster etc

Dampen the wall before application of thin set adhesive

Clean the back of tile for any dust or coating

 

Mixing: The products can be mixed by hand or slow speed electric drill mixer (less than 300 rpm). Pour potable clean water in a clean container and then add the powder LATAFIX® 305 and mix until the mixture becomes creamy and plastic. Do not over mix. Leave the mix to slake for 5-10 min and remix before use. Mix only sufficient quantity of adhesive for immediate need.

 

Proportion: Approximately 1 bag of LATAFIX® 305 with 5-6 ltrs of water. Adjust quantity of liquid to obtain proper consistency.

 

Available in White color also.

LATICRETE® 307 floor and wall tile adhesive is a smooth and creamy thin-set Adhesive for installing small to medium format ceramic wall and floor tiles in interior areas. For improved performance and exterior use, fortify with LATICRETE® 73 Crete Admix.
Features and benefits:For fixing ceramic tiles on interior floor & wallIdeal for new floor tilingSmooth & CreamySingle component - Just add water
Certification:ANSI: 118.1 TEN 12004/ISO 13007:CITIS 15477:2019: TYPE 1  T ADHESIVEVOC:Practically Nil
How to apply:
Substrate: The surface to be covered with Ceramic tile shall be sound and confirm to good design, rigid, clean and free of dirt, oil, grease, curing compounds, form release agents or loose plaster and paint. For economy the surfaces should be level and true with in: Walls – 3mm in 2.5m Floors – 1.5mm in 1.0m
Surface Preparation:If a plaster/leveling mortar bed is applied, ensure that it is cured for at least 7 days to achieve proper strength before application of tile adhesive for installation of tileEnsure the substrate is clean and free from impurities like dust, dirt, debris, oil, grease, curing agents, loose plaster etcDampen the wall before application of thin set adhesiveClean the back of tile for any dust or coating
Mixing: The products can be mixed by hand or slow speed electric drill mixer (less than 300 rpm). Pour potable clean water in a clean container and then add the powder LATICRETE® 307 and mix until the mixture becomes creamy and plastic. Do not over mix. Leave the mix to slake for 5-10 min and remix before use. Mix only sufficient quantity of adhesive for an immediate need.Proportion: Approximately 1 bag of LATICRETE® 307 with 5-6 ltrs of water. Adjust the quantity of liquid to obtain proper consistency.
Available in Grey color also.